Chevrolet Cruze I facelift (2012-2015) w/ remote start wiring diagram
This page shows the only wiring diagram for the component.w/ remote start, which is found in the car Chevrolet Cruze I facelift (2012-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
w/ remote start wiring diagram (1 of 1)
5 VOLT REF
6 SPEED A/T
BLK WIRE
BLK/BRN WIRE
BLU WIRE
BLU/YEL WIRE
BODY CONTROL MODULE (BCM)
BODY CONTROL MODULE (BCM) (UNDER CENTER DASH)
BRAKE PEDAL POSITION SENSOR
BRAKE PEDAL POSITION SENSOR (TOP OF BRAKE PEDAL ASSEMBLY)
BRK PDL POS SENS SIG
COMPUTER DATA LINES SYSTEM
DK BLU WIRE
ENGINE CONTROL MODULE (ECM)
ENGINE CONTROL MODULE (ECM) (1.8L: LEFT SIDE OF ENGINE COMPT)
FUSE 22
FUSE 32
HOT AT ALL TIMES
HOT AT ALL TIMES INSTRUMENT PANEL FUSE FUSE BLOCK (BEHIND LEFT END OF DASH)
IGN VOLT
IGNITION SWITCH
INSTRUMENT PANEL FUSE BLOCK
KEY CAPTURE SOLENOID ACTUATOR
KEY-IN IGNITION SWITCH
LOW REF
M/T A/T
OFF
PARK POSITION SWITCH
RED/VIO WIRE
RUN WIRE
SERIAL DATA
SPLY VOLT
TRANSMISSION SHIFT LEVER
UNDERHOOD FUSE BLOCK
VIO WIRE
VIO/YEL WIRE
W/ REMOTE START
W/O REMOTE START
WHT WIRE
WHT/VIO WIRE
YEL WIRE
Go to component -> Ignition lock solenoid circuit -> W/ REMOTE START
