Chevrolet Cruze I facelift (2012-2015) automatic transmission assembly control solenoid valve assembly Wiring diagram
This page shows the only wiring diagram for the component.automatic transmission assembly control solenoid valve assembly, which is found in the car Chevrolet Cruze I facelift (2012-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram automatic transmission assembly control solenoid valve assembly (1 of 1)
275 (OR 1786)
5 VOLT REF
AUTOMATIC TRANSMISSION ASSEMBLY CONTROL SOLENOID VALVE ASSEMBLY
BLK WIRE
BLK/BRN WIRE
BLU WIRE
BLU/YEL WIRE
BODY CONTROL MODULE (BCM)
BODY CONTROL MODULE (BCM) (UNDER CENTER DASH)
BRAKE PEDAL POSITION SENSOR
BRAKE PEDAL POSITION SENSOR (TOP OF BRAKE PEDAL ASSEMBLY)
BRK PDL POS SENS SIG
COMPUTER DATA LINES SYSTEM
DK BLU WIRE
ENGINE CONTROL MODULE (ECM)
ENGINE CONTROL MODULE (ECM) (1.8L: LEFT SIDE OF ENGINE COMPT)
FUSE 32
GRN (OR WHT/GRY) WIRE
HOT AT ALL TIMES
LOW REF
M/T A/T
ORG/ WIRE
PARK LOCK SLND CTRL
PARK/NEUTRAL
PARK/NEUTRAL SIG (1) BRK PDL POS SENS SIG
RED/VIO WIRE
SERIAL DATA
SIG (1)
SPLY VOLT
TRANS- MISSION CONTROL MODULE
TRANS- MISSION INTERNAL MODE SWITCH
TRANSMISSION MANUAL SHIFT SWITCH
TRANSMISSION SHIFT LEVER
TRANSMISSION SHIFT LOCK CONTROL SOLENOID ACTUATOR
UNDERHOOD FUSE BLOCK
VIO WIRE
VIO/BLK WIRE
WHT WIRE
Go to component -> Shift interlock circuit -> AUTOMATIC TRANSMISSION ASSEMBLY CONTROL SOLENOID VALVE ASSEMBLY
