Chevrolet Cobalt I (2004-2010) steering shaft torque sensor Wiring diagram
This page shows the only wiring diagram for the component.steering shaft torque sensor, which is found in the car Chevrolet Cobalt I (2004-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram steering shaft torque sensor (1 of 1)
B(+)
BLK WIRE
BODY CONTROL MODULE (BCM) (UNDER CENTER DASH, ON RIGHT SIDE OF CENTER CONSOLE)
BRN WIRE
CLASS 2 SERIAL DATA
COMPT, NEXT TO LEFT STRUT TOWER)
COMPUTER DATA LINES SYSTEM
CRUISE CONTROL SYSTEM
ELECTRIC POWER STEERING (EPS) MOTOR
EPS FUSE
EPS/ STR WHL CNTRL FUSE 19
GROUND
HOT AT ALL TIMES
HOT IN RUN OR START
IGNITION 1
LOGIC
PNK WIRE
POWER STEERING CONTROL MODULE (PSCM)
RED WIRE
RED/BLK WIRE
STEERING COLUMN ASSEMBLY
STEERING SHAFT TORQUE SENSOR
TAN WIRE
UNDERHOOD FUSE BLOCK (IN ENGINE
WHT WIRE
Go to component -> Electronic power steering circuit -> STEERING SHAFT TORQUE SENSOR
