Chevrolet Cobalt I (2004-2010) park brake switch signal Wiring diagram
This page shows the only wiring diagram for the component.park brake switch signal, which is found in the car Chevrolet Cobalt I (2004-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram park brake switch signal (1 of 1)
2.2L 2.4L
ABS INDICATOR
BATT POS VOLTAGE
BLK WIRE
BLK/WHT WIRE
BODY CONTROL MODULE (BCM) (UNDER CENTER DASH)
BRAKE FLUID LEVEL SENSOR SIGNAL
BRAKE FLUID LEVEL SWITCH (IN REAR OF ENGINE COMPT, ATTACHED TO MASTER CYLINDER)
BRAKE INDICATOR
CLSTR FUSE
COMPUTER DATA LINES SYSTEM
DK GRN WIRE
ENGINE CONTROL MODULE (ECM) (LEFT SIDE OF ENGINE COMPT, IN FRONT OF
GROUND
HI SPD GMLAN SER DATA -
HI SPD GMLAN SERIAL DATA
HOT AT ALL TIMES
IGN
INSTRUMENT PANEL CLUSTER
LEFT REAR WHEEL SPEED SENSOR (WSS) (INSIDE LEFT REAR WHEEL HUB)
LO SPD GMLAN SERIAL DATA
LOGIC
LOW SPD GMLAN SER DATA
LT BLU WIRE
ON RIGHT SIDE OF CENTER CONSOLE)
ORG/ WIRE
PARK BRAKE SWITCH (IN CENTER CONSOLE, ATTACHED TO PARKING BRAKE)
PARK BRAKE SWITCH SIGNAL
PNK WIRE
RED WIRE
RED/WHT WIRE
SERIAL DATA
TAN WIRE
TAN/BLK WIRE
TRACTION OFF IND
UNDERHOOD FUSE BLOCK
Go to component -> Anti-lock brakes circuit, without vsc (2 of 2) -> PARK BRAKE SWITCH SIGNAL
