Chevrolet Chevy Van G10 (1985-1995) range mode selector Wiring diagram
This page shows the only wiring diagram for the component.range mode selector, which is found in the car Chevrolet Chevy Van G10 (1985-1995). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram range mode selector (41 of 41)
1-2 SHIFT SOL
2-3 SHIFT SOL
ALT FUSE
BLK WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BRN WIRE
BRN/WHT WIRE
DATA LINK CONNECTOR (BELOW LEFT SIDE OF DASH)
DK BLU WIRE
DK BLU/WHT WIRE
ECM BAT FUSE
ECM-CRNK FUSE
ENGINE COOLANT TEMPERATURE (ECT) SENSOR (TOP FRONT OF ENGINE)
GRY WIRE
GRY/RED WIRE
HOT AT ALL TIMES
HOT IN RUN OR START
HOT IN RUN, BULB TEST OR START
I/P FUSE BLOCK
INSTRUMENT CLUSTER
LT BLU WIRE
LT BLU/WHT WIRE
LT GRN WIRE
ORG/ WIRE
ORG/BLK WIRE
PNK WIRE
PNK/BLK WIRE
POWERTRAIN CONTROL MODULE (PCM) (LEFT SIDE OF DRIVER'S ISLAND)
PPL
PPL PNK WIRE
PRESSURE CONTROL SOLENOID
RANGE MODE SELECTOR
RED WIRE
RED/BLK WIRE
SERVICE ENGINE SOON
SPEED SENSOR (LEFT REAR SIDE OF TRANSMISSION)
TAN WIRE
TCC PWM SOL
TCC/BRAKE SWITCH (ON BRAKE PEDAL BRACKET)
THROTTLE POSITION SENSOR (RIGHT SIDE OF TBI)
TRANS FLUID TEMP (TFT) SENSOR
TRANS FUSE
TRANSMISSION
TRANSMISSION INPUT SHAFT SPEED SENSOR (FRONT OF TRANSMISSION)
VEHICLE SPEED SENSOR BUFFER
WHT/BLK WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> 7.4l (vin n), transmission circuit -> RANGE MODE SELECTOR
