Chevrolet Captiva I facelift (2011-2013) w/o vehicle tracking, restart prevention Wiring diagram
This page shows the only wiring diagram for the component.w/o vehicle tracking, restart prevention, which is found in the car Chevrolet Captiva I facelift (2011-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram w/o vehicle tracking, restart prevention (1 of 1)
2.4L
2.4L PNK/ WIRE
3.0L
3.0L 2.4L EVAPORATIVE EMISSION (EVAP) CANISTER PURGE SOLENOID VALVE (3.0L)
A/C FUSE
A/C RELAY
BANK 1 SENSOR 1 (3.0L)
BANK 1 SENSOR 2
BANK 2 SENSOR 1
BANK 2 SENSOR 2
BCM (CTSY)
BCM (PRK/TRN) BCM (STOP)
BCM (TRN SIG) FUSE
BCM BCM BCM (DIMMER) (VBATT) (INT LIGHT) FUSE FUSE FUSE
BLK WIRE
BODY CONTROL MODULE (BCM)
ENG SNSR FUSE
FROM BCM (PRK/TRN) S/ROOF FUSE (DIAGRAM BATT 2 OF 4) FUSE
FROM FRT WPR FUSE (DIAGRAM 1 OF 4)
FROM IGN COIL B FUSE (DIAGRAM 1 OF 4)
FROM PWR DIODE (DIAGRAM 4 OF 4)
FROM UNDERHOOD FUSE BLOCK (DIAGRAM 1 OF 4)
FSCM/ VENT SOL
FUEL PUMP FLOW CONTROL MODULE
FUSE
FUSE FUSE
GARAGE I/P DOOR MULTI- OPENER FUNCTION SWITCH (GDO)
HEATED OXYGEN SENSOR
I/P FUSE BLOCK
IGNITION SWITCH
KEY-IN IGNITION SWITCH
LOCK
LOCK LOCK
MASS AIR FLOW (MAF) SENSOR/ INTAKE AIR TEMPERATURE (IAT) SENSOR
PNK WIRE
PWR/MODING FUSE
RED WIRE
RELAY
RELAY/ FUSE
RUN WIRE
RVS/ LOGISTIC HVAC/DLC MODE FUSE FUSE
S/ROOF FUSE
SDM (BATT)
SUNROOF CONTROL MODULE
TELEMATIC
TELEMATIC VEHICLE LOCALIZATION, IMMOBILIZATION CONTROL MODULE
THEFT DETERRENT MODULE (TDM) W/ VEHICLE TRACKING, RESTART PREVENTION
TO CIGAR FUSE (DIAGRAM 4 OF 4)
TO S/ROOF FUSE
W/O VEHICLE TRACKING, RESTART PREVENTION
WHT WIRE
YEL WIRE
Go to component -> Power distribution circuit (2 of 4) -> W/O VEHICLE TRACKING, RESTART PREVENTION
