Chevrolet Captiva I facelift (2011-2013) (in exhaust system, downstream of left catalytic converter) wiring diagram
This page shows the only wiring diagram for the component.(in exhaust system, downstream of left catalytic converter), which is found in the car Chevrolet Captiva I facelift (2011-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(in exhaust system, downstream of left catalytic converter) wiring diagram (1 of 1)
BANK 1 SENSOR 1 HEATED OXYGEN
BANK 1 SENSOR 2 HEATED OXYGEN
BANK 1 SNSR (1) BANK 1 SNSR (2) MAP SNSR SIG
BANK 1 SNSR (1) BANK 2 SNSR (1) BANK 1 SNSR (2) BANK 2 SNSR (2)
BANK 2 SENSOR 1 HEATED OXYGEN
BANK 2 SENSOR 2 HEATED OXYGEN
BLK WIRE
BLK/WHT WIRE
BRN WIRE
DK BLU WIRE
ECM PWR TRN FUSE
ENG SNSR FUSE
ENGINE CONTROL MODULE (ECM) (LEFT FRONT ENGINE COMPT)
ENGINE CONTROLS IGNITION RELAY
FUEL ECONOMY
FUEL RAIL PRESSURE (FRP)
GRY WIRE
GRY/WHT WIRE
HOT AT ALL TIMES
IGN COIL A FUSE
IGN COIL B FUSE
KNOCK SNSR SIG (1) KNOCK SNSR SIG (2)
LT BLU WIRE
LT GRN WIRE
MASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR (IN AIR BOX)
MODE SWITCH
NCA WIRE
ORG/WHT WIRE
PNK/BLK WIRE
PNK/WHT WIRE
PPL
PPL PPL
PPL SNSR SIG CTRL CLOSE
PPL/WHT WIRE
RAIL)
SENSOR (IN FUEL
SIG GND CTRL OPEN
SNSR LO REF
SNSR SIG
SNSR SIG SW SIG
TAN WIRE
TAN/WHT WIRE
UNDERHOOD FUSE BLOCK (LEFT SIDE OF ENGINE COMPT)
YEL WIRE
YEL/WHT WIRE
Go to component -> Wiring diagram engine performance 3.0l vin 5 (6 of 6) -> (IN EXHAUST SYSTEM, DOWNSTREAM OF LEFT CATALYTIC CONVERTER)
