Chevrolet Caprice Impala SS (1995-1996) power reset solid state Wiring diagram
This page shows the only wiring diagram for the component.power reset solid state, which is found in the car Chevrolet Caprice Impala SS (1995-1996). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram power reset solid state (1 of 1)
1995 VFTC
4.5-7 MINUTES MAXIMUM. C-CLOSES WITH VEHICLE TOO LOW.
AUTOMATIC LEVEL CONTROL SENSOR (BOLTED TO REAR CROSSMEMBER, NEAR CENTER)
BLK WIRE
COM- PRESSOR MOTOR RELAY
COMPRESSOR SIGNAL
ELC FUSE #1
EXHAUST
EXHAUST VALVE
HOT AT ALL TIMES
HOT IN RUN, BULB TEST OR START HOT AT ALL TIMES TRK LP FUSE 27 BODY FUSE 12
I/P FUSE BLOCK
LEVEL TOO LOW FROM ACTU- ATOR ARM TOO HIGH
NCA WIRE
NORMAL EXHAUST SOLENOID COM- PRESSOR MOTOR
ORG/ WIRE
PNK WIRE
POWER RESET SOLID STATE
UNDERHOOD ELECTRICAL CENTER
VENT
WHT WIRE
YEL WIRE
Go to component -> Electronic level control -> POWER RESET SOLID STATE
