Chevrolet Camaro IV facelift (1998-2002) on/off input Wiring diagram
This page shows the only wiring diagram for the component.on/off input, which is found in the car Chevrolet Camaro IV facelift (1998-2002). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram on/off input (1 of 1)
4000 PULSES/MILE
A/C-CRUISE FUSE
A/T A/T
BLK WIRE
BOTTOM UNDERHOOD FUSE BLOCK (LEFT FRONT CORNER OF ENGINE COMPT)
BRAKE INPUT
BRN WIRE
BRN/WHT WIRE
CLUTCH PEDAL POSITION (CPP) SWITCH (ON CLUTCH PEDAL BRACKET)
CRUISE CONTROL MODULE (ENGINE COMPT, ON LEFT
CRUISE CONTROL RELEASE/TCC BRAKE SWITCH (ON BRAKE PEDAL BRACKET)
CRUISE ENGAGED
CRUISE INHIBIT
CRUISE STATUS
CRUISE SWITCH
DK BLU WIRE
DK GRN WIRE
DK GRN/WHT WIRE
ENGINE CONTROL SYSTEM
FRAME RAIL)
GROUND PNK IGNITION INPUT WIRE
GRY WIRE
GRY/BLK WIRE
HOT AT ALL TIMES
HOT IN RUN, BULB TEST OR START
I/P FUSE BLOCK (BEHIND LEFT SIDE OF DASH)
LT BLU WIRE
LT GRN/BLK WIRE
M/T
MULTI- FUNCTION TURN SIGNAL LEVER
NCA WIRE
OFF
OFF ON
ON/OFF INPUT
ORG/ WIRE
PNK PNK WIRE
PNK WIRE
POWERTRAIN CONTROL MODULE (PCM) (IN ENGINE COMPT, BEHIND RIGHT STUT TOWER)
PPL/WHT WIRE
R/A
RESUME/ACCEL INPUT
SET/ COAST SW
SET/COAST INPUT
STOP/HAZARD FUSE 1
STOPLIGHT SWITCH (ON BRAKE PEDAL BRACKET)
VEHICLE SPEED SENSOR (REAR SIDE OF TRANSMISSION)
VSS INPT HI
VSS INPUT
VSS INPUT-LO
WHT WIRE
Go to component -> 5.7l vin g, cruise control circuit -> ON/OFF INPUT
