Chevrolet Camaro IV (1992-1998) second gear Wiring diagram
This page shows the only wiring diagram for the component.second gear, which is found in the car Chevrolet Camaro IV (1992-1998). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram second gear (1 of 1)
3-2 CTRL SOL 1-2 CTRL SOL
6 15 16 19 20 21 22 26 28 47 56 59 60 67 68 75 VSS IN UART DATA LINK
800 1807 9 2 PPL
ACTUATORS FUSE 2
BLK WIRE
BLK/WHT WIRE
BRN WIRE
CRUISE CONTROL SYSTEM
DATA LINK CONNECTOR (UNDER LEFT SIDE OF DASH)
DK BLU WIRE
ENG SENS FUSE 10
ENGAGED INDICATOR
GAUGES FUSE 9
GRY WIRE
HOT AT ALL TIMES
HOT IN RUN
HOT IN RUN, BULB TEST OR START
I/P FUSE BLOCK
ILLUM
INSTRUMENT CLUSTER
LT BLU WIRE
LT BLU/BLK WIRE
LT BLU/WHT WIRE
LT GRN WIRE
ORG/ WIRE
PCM BAT FUSE 3
PCM IGN FUSE 13
PCS SOL
PNK WIRE
PONTIAC
POWERTRAIN CONTROL MODULE (RIGHT SIDE OF ENGINE COMPT)
PPL
RED WIRE
RED/BLK WIRE
RNGE 'A'
RNGE 'B'
RNGE 'C'
SECOND GEAR
SECOND GEAR START SWITCH
STOPLAMP/ TCC SWITCH (UNDER LEFT SIDE OF DASH)
TAN WIRE
TAN/BLK WIRE
TCC PWM SOL
TCC SOL 2-3 CTRL SOL
TFT SENSOR
THROTTLE POSITION SENSOR (THROTTLE BODY)
TR PRESSURE SWITCH ASSY
TRANS- MISSION
TURN B/U FUSE 2
UNDERHOOD ELECTRICAL CENTER
VEHICLE SPEED SENSOR (LEFT REAR OF TRANSMISSION)
WHT WIRE
WHT/BLK WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> 3.8l (vin k), transmission circuit -> SECOND GEAR
