Chevrolet Camaro IV (1992-1998) pontiac solid state chevrolet Wiring diagram
This page shows the only wiring diagram for the component.pontiac solid state chevrolet, which is found in the car Chevrolet Camaro IV (1992-1998). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram pontiac solid state chevrolet (1 of 1)
ABS ASR/TCS RELAY
ABS BAT FUSE 6
ABS IGNITION FUSE 1
ABS INOP INDICATOR
ABS MOTOR PACK
ABS VALVE FUSE 5
BLK WIRE
BLK/WHT WIRE
BRAKE COMBO VALVE
BRAKE IN BATT
BRAKE INDICATOR
BRAKE SWITCH ASSEMBLY (BRAKE PEDAL BRACKET)
BRN WIRE
DATA LINK CONNECTOR (RIGHT OF STEERING COLUMN)
DK BLU WIRE
DK GRN WIRE
ELECTRONIC BRAKE CONTROL MODULE (EBCM) (LEFT SIDE OF I/P)
FUSIBLE LINK B
GAGES FUSE 9
HOT AT ALL TIMES
HOT IN
HOT IN RUN, BULB TEST OR START
HYDRAULIC MODULATOR ASSEMBLY (LEFT FRONT OF ENGINE COMPT)
I/P FUSE BLOCK
IGN LEFT FRONT SOLENOID RLY COIL CTRL
INSTRUMENT CLUSTER
INSTRUMENT CLUSTER SYSTEM (BRAKE WARNING)
LEFT FRONT ABS BRAKE PRESSURE VALVE SOLENOID
LEFT FRONT MOTOR
LEFT FRONT WHEEL SPEED SENSOR
LOW TRACTION INDICATOR
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
PNK WIRE
PONTIAC SOLID STATE CHEVROLET
PPL
PPL 1282 1283 1633
PPL PPL
REAR MOTOR
REAR WHEEL SPEED SENSOR
RED WIRE
RIGHT FRONT ABS BRAKE PRESSURE VALVE SOLENOID
RIGHT FRONT MOTOR
RIGHT FRONT WHEEL SPEED SENSOR
RUN WIRE
SERIAL DATA
STOP/HAZARD FUSE 1
TAN WIRE
TAN/WHT WIRE
UNDERHOOD ELECTRICAL CENTER
WHT WIRE
YEL WIRE
Go to component -> Anti-lock brake circuits, without traction control -> PONTIAC SOLID STATE CHEVROLET
