Chevrolet Camaro IV (1992-1998) input mode Wiring diagram
This page shows the only wiring diagram for the component.input mode, which is found in the car Chevrolet Camaro IV (1992-1998). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram input mode (1 of 1)
22 23 PNK WIRE
ABS BAT FUSE 6
ABS IGN FUSE 1
ABS INOP IND
ABS RELAY
ABS VALVE FUSE 5
ADJUSTER ASSEMBLY
ASR IND (CHEVROLET) TCS OFF IND (PONTIAC)
BLK WIRE
BLK/WHT WIRE
BRAKE IND
BRAKE SWITCH ASSEMBLY (ON BRAKE PEDAL BRACKET)
BRN WIRE
BRN/WHT WIRE
CHEVROLET PONTIAC
CRUISE CONTROL SYSTEM
CTRL IND
DATA LINK CONNECTOR (RIGHT OF STEERING COLUMN)
DK BLU WIRE
DK GRN WIRE
FUSE LINK B
GAGES FUSE 9
GRY WIRE
HOT AT ALL TIMES
HOT IN
HOT IN RUN, BULB TEST OR START
I/P FUSE BLOCK
IGN LEFT FRONT SOL ABS ENABLE RELAY CTRL
INPUT MODE
INSTRUMENT CLUSTER
INSTRUMENT CLUSTER SYSTEM (BRAKE WARNING)
LEFT REAR MOTOR CONTROL
LO HI LO HI RIGHT REAR MOTOR CONTROL 566 565 564
LOW TRAC IND
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
ORG/BLK WIRE
PNK WIRE
PONTIAC CHEVROLET
POWERTRAIN CONTROL MODULE (PCM) (REAR OF RIGHT SHOCK TOWER)
PPL
PPL PPL 1 2
PPL/WHT WIRE
REAR ABS MOTOR 1280 1281 LEFT FRONT MOTOR CONTROL PNK WIRE
RED WIRE
RUN WIRE
SOLID STATE
SPARK RETARD
STOP/HAZ FUSE 1
TAN WIRE
TAN/BLK WIRE
TAN/WHT WIRE
TCS ACTIVE
TCS ENABLE SW SIGNAL BATTERY POWER
TP SENS SIGNAL
TPS SIG SPARK RETARD REQUEST TCS MOTOR RETURN
TRACTION CONTROL MOTOR PACK (BELOW HYDRAULIC MODULATOR ASSEMBLY)
UNDERHOOD ELECTRICAL CENTER
VIN K ONLY
WHT WIRE
YEL WIRE
Go to component -> Anti-lock brake circuits, with traction control (1 of 2) -> INPUT MODE
