Chevrolet Beretta I (1987-1996) vin a and vin 4 with manual transaxle Wiring diagram
This page shows the only wiring diagram for the component.vin a and vin 4 with manual transaxle, which is found in the car Chevrolet Beretta I (1987-1996). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram vin a and vin 4 with manual transaxle (1 of 1)
AUTO DOOR UNLOCK MODULE
BLK WIRE
BLK/WHT WIRE
BRN/BLK WIRE
CIRCUIT BREAKER 15
DK GRN WIRE
DOOR LOCK RELAY ASSEMBLY (BEHIND LEFT LOWER KICK PANEL)
ENGINE CONTROL MODULE
ENGINE CONTROLS SYSTEM
FUSE 11
FUSE 17
FUSE 9
FUSE BLOCK
GRY WIRE
HOT AT ALL TIMES
HOT IN RUN, BULB TEST OR START
IGN
LEFT DOOR LOCK SWITCH
LEFT FRONT DOOR LOCK MOTOR
LEFT REAR DOOR LOCK MOTOR
LOCK
LOCK RELAY
LT BLU WIRE
MULTI-FUNCTION ALARM MODULE
ORG/ WIRE
ORG/BLK WIRE
PARK/ NEUTRAL INPUT
PARK/ NEUTRAL POSITION SWITCH (TOP RIGHT SIDE OF TRANSAXLE)
PNK WIRE
RELAY CONTROL
RIGHT DOOR LOCK SWITCH
RIGHT FRONT DOOR LOCK MOTOR
RIGHT REAR DOOR LOCK MOTOR
RIGHT REAR OF ENGINE, ON TRANSAXLE STUD)
SOLID STATE
TAN WIRE
UNLOCK
UNLOCK CONTROL
UNLOCK RELAY
VEHICLE SPEED INPUT
VIIN 4 WITH A/T
VIN A AND VIN 4 WITH MANUAL TRANSAXLE
WHT WIRE
Go to component -> Power door lock circuit -> VIN A AND VIN 4 WITH MANUAL TRANSAXLE
