Chevrolet Beretta I (1987-1996) regulator field (solid state) (rotor) wiring diagram
This page shows the only wiring diagram for the component.regulator field (solid state) (rotor), which is found in the car Chevrolet Beretta I (1987-1996). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
regulator field (solid state) (rotor) wiring diagram (1 of 1)
BASE CLUSTER ONLY
BATTERY
BLK WIRE
BRN WIRE
CHARGE IND
FUSE 9 FUSE 4
FUSE BLOCK
FUSIBLE LINK
FUSIBLE LINK (16 GA-RUST)
FUSIBLE LINK (20 GA-RUST)
GENERATOR (UPPER RIGHT FRONT OF ENGINE) TURN ON INPUT TURN ON INPUT
GROUND DISTRIBUTION
HOT IN RUN
HOT IN RUN, BULB TEST OR START
INSTRUMENT CLUSTER
PNK WIRE
POWER DISTRIBUTION
RECTIFIER BRIDGE
RED WIRE
REGULATOR FIELD (SOLID STATE) (ROTOR)
STARTER SOLENOID (LOWER LEFT REAR OF ENGINE)
STATOR
VOLTAGE SENSING INPUT
Go to component -> Charging circuit -> REGULATOR FIELD (SOLID STATE) (ROTOR)
