Chevrolet Beretta I (1987-1996) oil level signal Wiring diagram

5 VOLTS REF A/C PRESS SIGNAL A/C REQUEST A/C SENSOR (RIGHT FRONT OF ENGINE COMPT) BATTERY REF BLK WIRE BLK/WHT WIRE BRN WIRE CRANK SENS OUTPUT CRANK SENSOR B+ FEED CRANK SENSOR GRD CRANK SHAFT POSITION SENSOR (LOWER RIGHT SIDE OF ENGINE) DK BLU WIRE DK GRN WIRE DK GRN/WHT WIRE ECT SENSOR IN ENGINE CONTROL MODULE (ECM) (BEHIND RIGHT SIDE OF I/P, NEAR SHROUD) ENGINE COOLANT TEMPERATURE SENSOR (LEFT SIDE OF ENGINE) FUEL INJECTOR 1 FUEL INJECTOR 2 FUEL INJECTOR 3 FUEL INJECTOR 4 FUEL PUMP RELAY CTRL FUSE 16 FUSE BLOCK FUSIBLE LINK (20 GA-GRAY) GROUND GRY WIRE HEATER AND A/C CTRL ASSEMBLY HOT AT ALL TIMES HOT IN RUN, BULB TEST OR START IAC A HI IAC A LO IAC B HI IAC B LO IAT SENSOR IN IGN CTRL A OUT IGN CTRL B OUT INJECTOR 1, 4 CTRL INJECTOR 2, 3 CTRL INSTRUMENT CLUSTER INSTRUMENT CLUSTER, CRUISE CONTROL AND CONVENIENCE CENTER LT BLU/BLK WIRE LT BLU/WHT WIRE LT GRN WIRE LT GRN/BLK WIRE LT GRN/WHT WIRE MAP SENSOR (TOP LEFT REAR OF ENGINE, NEAR THROTTLE BODY) MAP SIGNAL IN OIL LEVEL SIGNAL ORG/ WIRE ORG/BLK WIRE OXYGEN SENSOR (REAR OF ENGINE ON EXHAUST MANIFOLD) OXYGEN SENSOR IN-HI OXYGEN SENSOR IN-LO PNK WIRE PNK/BLK WIRE PPL RED WIRE RED/BLK WIRE RIGHT REAR OF ENGINE, ON TRANSAXLE STUD) SENSOR GROUND TACH TAN WIRE TAN/WHT WIRE TPS VSS OUT WHT WIRE YEL WIRE