Chevrolet Astro I (1985-2005) headlp enable hi beam sig Wiring diagram
This page shows the only wiring diagram for the component.headlp enable hi beam sig, which is found in the car Chevrolet Astro I (1985-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram headlp enable hi beam sig (1 of 1)
AMBIENT LIGHT SENSOR (TOP CENTER OF DASH)
BLK WIRE
BODY CONTROL MODULE (BCM) (ABOVE RADIO)
COMPOSITE HEADLAMPS
DAYTIME RUNNING LAMPS DIODE (ON LOWER PART OF LEFT "B" PILLAR)
DAYTIME RUNNING LAMPS RELAY
DK BLU WIRE
DRL RELAY CRTL
FLASH TO PASS
GAUGES FUSE 4
GRY WIRE
HEAD
HEADLAMP RELAY
HEADLAMP, PANEL DIMMER SWITCH
HEADLP ENABLE HI BEAM SIG
HEADLP REQ FLASH TO PASS
HOT AT ALL TIMES
HOT IN RUN OR START
I/P FUSE BLOCK (BEHIND LEFT SIDE OF DASH)
LEFT HEADLAMP
LEFT HIGH BEAM HEADLAMP
LEFT LOW BEAM HEADLAMP
LIGHTING FUSE
LT BLU WIRE
LT GRN WIRE
LT GRN/BLK WIRE
MULTIFUNCTION TURN SIGNAL LEVER
OFF ON LO
ORG/ WIRE
PARK AUTO
PARK AUTO HEAD
PHOTO CELL
PNK WIRE
PPL
PPL/WHT WIRE
RED WIRE
RELAY BLOCK 2 (BEHIND LEFT SIDE OF DASH)
RH HDLP FUSE
RIGHT HEADLAMP
RIGHT HIGH BEAM HEADLAMP
RIGHT LOW BEAM HEADLAMP
SEALED BEAM HEADLAMPS
TAN WIRE
TAN/WHT WIRE
TBC FUSE 15
UNDERHOOD FUSE BLOCK (ON LEFT SIDE OF FIREWALL)
WHT WIRE
YEL WIRE
Go to component -> Headlights circuit -> HEADLP ENABLE HI BEAM SIG
