Cadillac XT4 I (2018-2023) entertainment remote enable sig Wiring diagram

This page shows the only wiring diagram for the component.entertainment remote enable sig, which is found in the car Cadillac XT4 I (2018-2023). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..

Wiring diagram entertainment remote enable sig (1 of 1)

AUDIO AMPLIFIER (UNDER FRONT OF CENTER FLOOR CONSOLE) BATTERY POSITIVE VOLTAGE BLK WIRE BLU WIRE BLU/BLK WIRE BLU/BRN WIRE BLU/VIO WIRE BLU/YEL WIRE BRN/BLK WIRE BRN/BLU WIRE BRN/VIO WIRE BRN/WHT WIRE CENTER INSTRUMENT PANEL SPEAKER COMPUTER DATA LINES SYSTEM CRANKSHAFT POSI SENS REPLICATED SIG ENTERTAINMENT REMOTE ENABLE SIG ETHERNET BUS 6 (-) FF MIDRANGE SPEAKER (-) LOW REF FR SPEAKER CONTROL (+) FR SPEAKER SIG (-) FRONT CENTER SPEAKER (-) CTRL FRONT CENTER SPEAKER (-) LOW REF GRN WIRE GRN/BLK WIRE GRN/BRN WIRE GRN/YEL WIRE GROUND GRY/BLK WIRE GRY/BLU WIRE GRY/BRN WIRE HOT AT ALL TIMES INSTRUMENT PANEL FUSE BLOCK LEFT FRONT DOOR SPEAKER LEFT INSTRUMENT PANEL SPEAKER LEFT REAR DOOR SPEAKER LF LOW LEVEL AUDIO (-) LOW REF LF LOW LVL AUDIO (-) LOW REF LF LOW LVL AUDIO SIG LF MIDRANGE SPEAKER (+) CTRL LF SPKR 1 (-) LF SPKR SIGNAL (-) 1 LR LOW LVL AUDIO SIG RR LOW LVL AUDIO SIG NOISE REDUCTION MICROPHONE 1 LOW REF NOISE REDUCTION MICROPHONE 1 SIG NOISE REDUCTION MICROPHONE 2 LOW REF NOISE REDUCTION MICROPHONE 2 SIG NOISE REDUCTION MICROPHONE 3 LOW REF NOISE REDUCTION MICROPHONE 4 RETURN NOISE REDUCTION MICROPHONE 3 SIG NOISE REDUCTION MICROPHONE 4 SIG RADIO AUDIO MUTE SIG RED/BRN WIRE RF LOW LVL AUDIO (-) LOW REF RF LOW LVL AUDIO SIG RF MIDRANGE SPEAKER (-) CTRL RF MIDRANGE SPEAKER (-) LOW REF RF SPEAKER (-) CTRL 1 RF SPKR SIG (-) (1) RIGHT FRONT DOOR SPEAKER RIGHT INSTRUMENT PANEL SPEAKER RIGHT REAR DOOR SPEAKER RR LOW LEVEL AUDIO (-) LOW REF RR SPEAKER (+) CTRL RR SPEAKER SIG (-) VIO/BLU WIRE WHT WIRE WHT/GRN WIRE WHT/YEL WIRE YEL WIRE YEL/BLK WIRE YEL/WHT WIRE

Go to component -> Navigation circuit, w/o surround amplifier (5 of 5) -> ENTERTAINMENT REMOTE ENABLE SIG