Cadillac XLR I (2003-2009) press brake to start Wiring diagram
This page shows the only wiring diagram for the component.press brake to start, which is found in the car Cadillac XLR I (2003-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram press brake to start (1 of 1)
AUTOMATIC TRANSMISSION PARK/ NEUTRAL SIGNAL
BATT 3 FUSE 26
BATTERY
BCM CLASS 2 SERIAL DATA
BCM IGNITION MODE DATA SIGNAL
BLK WIRE
BLK/WHT WIRE
BRAKE PEDAL POSITION SENSOR
BRAKE POSITION SENSOR SIGNAL
BRN WIRE
CHARGING CIRCUIT
COMPUTER DATA LINES SYSTEM
CRANK RELAY 43
ECM FUSE 16
ECM HIGH SPEED GMLAN SERIAL DATA BUS -
ENGINE CONTROL MODULE (ECM) (LOWER RIGHT REAR OF ENGINE COMPT)
GROUND
GRY WIRE
HIGH SPEED GMLAN SERIAL DATA BUS +
IGNITION MODE SWITCH
INSTRUMENT PANEL CLUSTER (IPC)
IPC CLASS 2 SERIAL DATA
LOGIC
LOW REF
LT GRN WIRE
LT GRN/WHT WIRE
MESSAGE CENTER
MESSAGE REQUEST
NCA WIRE
OFF
ORG/BLK WIRE
PARK/NEUTRAL SIGNAL
PNK WIRE
PPL
PRESS BRAKE TO START
RED WIRE
RUN/CRANK RELAY 7
RUN/CRANK RELAY CTRL
SPLICE PACK
STARTER
STARTER ENABLE RELAY CONTROL
STARTER FUSE 30
TAN WIRE
TAN/BLK WIRE
TEHC MODULE ASSEMBLY
UNDERHOOD FUSE BLOCK (RIGHT REAR OF ENGINE COMPT)
YEL WIRE
YEL/BLK WIRE
Go to component -> Starting circuit -> PRESS BRAKE TO START
