Cadillac Seville IV (1992-1997) puller cooling fan wiring diagram
This page shows the only wiring diagram for the component.puller cooling fan, which is found in the car Cadillac Seville IV (1992-1997). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
puller cooling fan wiring diagram (1 of 1)
4.9L
4.9L NORTHSTAR
808 401 400 PPL
BLK WIRE
BRN WIRE
COOLANT LEVEL SWITCH
COOLING FAN 1 RELAY (LEFT SIDE OF ENGINE COMPARTMENT)
COOLING FAN 2 RELAY (LEFT SIDE OF ENGINE COMPARTMENT)
COOLING FAN 3 RELAY (LEFT SIDE OF ENGINE COMPARTMENT)
DK BLU WIRE
DK GRN WIRE
ENGINE COMPARTMENT FUSE BLOCK
ENGINE COOLANT TEMPERATURE SENSOR (TOP LEFT OF ENGINE)
FUSE
HOT AT ALL TIMES
HOT IN RUN
LOWER RIGHT FRONT OF ENGINE)
LT BLU WIRE
LT GRN WIRE
MAXI FUSE 3
NORTHSTAR
ORG/BLK WIRE
POWER STEERING PRESSURE SWITCH (LOWER RIGHT REAR OF ENGINE)
POWERTRAIN CONTROL MODULE (BEHIND RIGHT SIDE OF I/P, TOP OF KICK PANEL)
PPL
PULLER COOLING FAN
PUSHER COOLING FAN
RED WIRE
RIGHT MAXI FUSE BLOCK
WHT WIRE
YEL WIRE
Go to component -> Cooling fan circuit -> PULLER COOLING FAN
