Cadillac Seville IV (1992-1997) inhibit output wiring diagram
This page shows the only wiring diagram for the component.inhibit output, which is found in the car Cadillac Seville IV (1992-1997). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
inhibit output wiring diagram (1 of 1)
1995 VFTC
4.9L NORTHSTAR
BLK/WHT WIRE
BULB TEST
CRANKING FUEL ENABLE INPUT
DK BLU WIRE
DK GRN WIRE
ENGINE COMPARTMENT FUSE BLOCK
FUEL ENABLE
FUSE
GROUND
HOT AT ALL TIMES
HOT IN RUN, BULB TEST OR START
IGNITION KEY
IGNITION KEY LOCK CYLINDER
IGNITION SWITCH
INHIBIT OUTPUT
INSTRUMENT CLUSTER
KEY RES IN (HI)
KEY RES IN (LO)
LOCK OFF
ORG/ WIRE
PASS-KEY DECODER MODULE (IN RIGHT ELECTRONICS BAY, MOUNTED ON BOARD)
PNK IGN WIRE
PNK WIRE
POWERTRAIN CONTROL MODULE (BEHIND RIGHT SIDE OF I/P)
PPL
PPL/WHT WIRE
RESISTOR PELLET
RUN WIRE
SECURITY IND CTRL
SECURITY INDICATOR
STARTER ENABLE CTRL
STARTER ENABLE RELAY (NEAR FRONT EDGE OF LEFT ROCKER PANEL CHANNEL)
STARTER INHIBIT IN
STARTER SOLENOID
TRUNK COMPARTMENT FUSE BLOCK
WHT WIRE
WHT/BLK WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> Pass-key circuit -> INHIBIT OUTPUT
