Cadillac DTS I (2005-2011) (body harness, 7 cm from breakout to battery current sensor) wiring diagram
This page shows the only wiring diagram for the component.(body harness, 7 cm from breakout to battery current sensor), which is found in the car Cadillac DTS I (2005-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(body harness, 7 cm from breakout to battery current sensor) wiring diagram (1 of 1)
2500 2501 COMPUTER DATA LINES SYSTEM
29 46 37 TRS SIG A TRS SIG B HI SPD SER DATA -
8 9 SERIAL DATA + SERIAL DATA -
AUTOMATIC TRANSMISSION
BATT POS VOLT
BCM (CHMSL) FUSE 39
BLK WIRE
BLK/WHT WIRE
BODY CONTROL MODULE (BCM) (RIGHT SIDE OF DASH)
COMPUTER DATA LINES SYSTEM
HI SPD SER DATA +
HOT AT ALL TIMES
INSIDE REARVIEW MIRROR (ISRVM)
LEFT BACKUP LAMP
LEFT TAIL LAMP ASSEMBLY
LOGIC
LT GRN WIRE
REAR FUSE BLOCK (UNDER LEFT REAR SEAT)
RIGHT BACKUP LAMP
RIGHT TAIL LAMP ASSEMBLY
SUPPLY VOLT
TAN WIRE
TAN/BLK WIRE
TAN/WHT WIRE
TRANSMISSION CONTROL MODULE (TCM) (LEFT FRONT STRUT TOWER)
TRANSMISSION INTERNAL MODE SWITCH (IMS)
VIO WIRE
YEL WIRE
YEL/VIO WIRE
Go to component -> Backup lamps circuit -> (BODY HARNESS, 7 CM FROM BREAKOUT TO BATTERY CURRENT SENSOR)
