Cadillac ATS I (2012-2014) (w/o headup display) collision alert indicators wiring diagram
This page shows the only wiring diagram for the component.(w/o headup display) collision alert indicators, which is found in the car Cadillac ATS I (2012-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(w/o headup display) collision alert indicators wiring diagram (1 of 1)
6 SPEED A/T
BATTERY
BATTERY CURRENT SENSOR
BATTERY SAVER RELAY 1
BLK WIRE
BLK/GRY WIRE
BLK/WHT WIRE
BRN WIRE
DATA LINK CONNECTOR
IGNITION MODE SWITCH
INFLATABLE RESTRAINT SENSING, DIAGNOSTIC MODULE
INSIDE REARVIEW MIRROR
INSTRUMENT PANEL DIMMER SWITCH
LAMP SWITCH BREAKOUT)
LEFT FRONT DOME/ READING LAMPS
LEFT INSTRUMENT PANEL COURTESY LAMP
LEFT STEERING WHEEL CONTROLS SWITCH
LEFT SUNSHADE
NCA WIRE
OVERHEAD CONSOLE ACCENT LAMP
REAR COMPARTMENT COURTESY LAMP
RED WIRE
RED/ BLK WIRE
RETAINED ACCESSORY POWER RELAY
RIGHT FRONT DOME/ READING LAMPS
RIGHT REAR WINDOW DEFOGGER NOISE FILTER
RIGHT STEERING WHEEL CONTROLS SWITCH
RIGHT SUNSHADE
STEERING WHEEL AIR BAG COIL
STEERING WHEEL ANGLE SENSOR
STEERING WHEEL HEATER
STEERING WHEEL HEATING CONTROL MODULE
TURN SIGNAL/ MULTI-FUNCTION SWITCH
W/ HEATED STEERING WHEEL
Go to component -> Ground distribution circuit (3 of 7) -> (W/O HEADUP DISPLAY) COLLISION ALERT INDICATORS
