Cadillac ATS I (2012-2014) w/ high pressure washer-headlamp wiring diagram
This page shows the only wiring diagram for the component.w/ high pressure washer-headlamp, which is found in the car Cadillac ATS I (2012-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
w/ high pressure washer-headlamp wiring diagram (1 of 1)
ACTIVE GRILLE AIR SHUTTER ACTUATOR
BLK WIRE
BLK/WHT WIRE
BRAKE BOOSTER PUMP MOTOR RELAY (3.6L)
BRN WIRE
DK BLU WIRE
FROM FRONT OBJECT SENSOR (RIGHT MIDDLE))
FRONT FASCIA)
HEADLAMP WASHER PUMP
IGNITION COIL 1
IGNITION COIL 3
IGNITION COIL 5
LEFT FRONT LEFT PARK/ TURN SIGNAL DAYTIME LAMP RUNNING LAMP
LEFT FRONT SIDE MARKER LAMP
LEFT HEADLAMP ASSEMBLY
LEFT HEADLAMP BALLAST
LEFT HEADLAMP HORIZONTAL MOTOR
LEFT HEADLAMP LEVELING ACTUATOR
LEFT HIGH LEFT LOW BEAM BEAM SOLENOID HEADLAMP ACTUATOR
LEFT RIGHT LOWER LOWER PARK/ PARK/ DAYTIME DAYTIME RUNNING RUNNING LAMP LAMP
NCA WIRE
POWER STEERING CONTROL MODULE
RIGHT FRONT SIDE MARKER LAMP
W/ HID
W/ HIGH PRESSURE WASHER-HEADLAMP
W/O HID
W/O HIGH PRESSURE WASHER-HEADLAMP
WHT/ BLK WIRE
WINDSHIELD WASHER FLUID LEVEL SWITCH
WINDSHIELD WASHER PUMP
WINDSHIELD WASHER PUMP RELAY
WINDSHIELD WIPER MOTOR
WINDSHIELD WIPER MOTOR CONNECTOR
WINDSHIELD WIPER RELAY
Go to component -> Ground distribution circuit (1 of 7) -> W/ HIGH PRESSURE WASHER-HEADLAMP
