Cadillac ATS I (2012-2014) placer in center to pin wiring diagram
This page shows the only wiring diagram for the component.placer in center to pin, which is found in the car Cadillac ATS I (2012-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
placer in center to pin wiring diagram (1 of 1)
BATT POS VOLT
BATTERY POSITIVE VOLT
BLK WIRE
BLK/YEL WIRE
COMPUTER DATA LINES SYSTEM
DETECTION INDICATOR
DRIVER OUTSIDE REARVIEW MIRROR
DRIVER SIDE OBJECT DETECTION INDICATOR DRIVER OUTSIDE REARVIEW MIRROR GLASS
GRN WIRE
GROUND
GRY WIRE
GRY/YEL WIRE
HOT W/ BATTERY SAVER RELAY 2 ENERGIZED
LEFT SIDE OBJECT SENSOR MODULE (LEFT REAR BUMPER FASCIA)
LOW SPEED GMLAN SERIAL DATA
MIRROR
MIRROR GLASS
PASS SIDE OBJECT DETECTION LED SIG (1)
PASSENGER OUTSIDE REARVIEW
PASSENGER SIDE OBJECT
PLACER IN CENTER TO PIN
REAR BODY FUSE BLOCK
RED/BLU WIRE
RED/GRN WIRE
RIGHT SIDE OBJECT SENSOR MODULE (RIGHT REAR BUMPER FASCIA)
SBZA/LDW/ EOCM FUSE
Go to component -> Blind spot monitoring circuit -> PLACER IN CENTER TO PIN
