Buick Skylark VII (1992-1998) steering wheel position sensor wiring diagram
This page shows the only wiring diagram for the component.steering wheel position sensor, which is found in the car Buick Skylark VII (1992-1998). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
steering wheel position sensor wiring diagram (1 of 1)
ABS ACTUATOR MOTOR ASSEMBLY (LEFT REAR OF ENGINE COMPT)
ABS FUSE
ABS IND.
ABS/EVO FUSE
BLK WIRE
BRAKE FLUID LEVEL SWITCH (IN BRAKE MASTER CYLINDER RES)
BRAKE IND
BRAKE SWITCH (BRAKE PEDAL SUPPORT BRACKET)
BRN WIRE
DATA LINE
DATA LINK CONNECTOR (DLC) (LEFT SIDE OF DASH)
DK GRN WIRE
ELECTRONIC BRAKE CONTROL MODULE (EBCM) (RIGHT REAR OF ENGINE COMPT.)
ELECTRONIC BRAKE CONTROL RELAY (LEFT REAR OF ENGINE COMPT)
ELECTRONIC VARIABLE EFFORT STEERING SOLENOID
ENGINE COMPARTMENT FUSE CENTER
ERLS FUSE
FUSE BLOCK
GRY WIRE
HOT AT ALL TIMES
HOT IN RUN, BULB TEST OR START
IGN
IND CTRL
INSTRUMENT PANEL CLUSTER
INT LPS FUSE
LEFT FRONT ABS SOLENOID
LEFT FRONT MOTOR
LEFT FRONT WHEEL SPEED SENSOR
LEFT REAR WHEEL SPEED SENSOR
LT BLU WIRE
MICROPROCESSOR
ORG/ WIRE
ORG/BLK WIRE
PNK WIRE
PPL
REAR MOTOR
RED WIRE
RIGHT FRONT ABS SOLENOID
RIGHT FRONT MOTOR
RIGHT FRONT WHEEL SPEED SENSOR
RIGHT REAR WHEEL SPEED SENSOR
STEERING WHEEL POSITION SENSOR
STOP/ HAZ FUSE
TAN WIRE
WHT WIRE
YEL WIRE
Go to component -> Anti-lock brake circuits -> STEERING WHEEL POSITION SENSOR
