Buick Roadmaster VIII (1991-1996) program input wiring diagram
This page shows the only wiring diagram for the component.program input, which is found in the car Buick Roadmaster VIII (1991-1996). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
program input wiring diagram (1 of 1)
ACTUATOR CONTROL
BACKUP LAMP AND TRANSMISSION POSITION SENSOR SWITCH
BATTERY
BLK WIRE
BLK/WHT WIRE
BRAKE SIGNAL
CHIME CONTROL
CHIME FUSE
CONVENIENCE CENTER (LEFT SIDE OF I/P, ABOVE FUSE BLOCK)
CTSY PWR LOCK FUSE
DK BLU WIRE
DOME AND COURTESY LAMP RELAY
DOOR LOCK OUTPUT
DOOR LOCK RELAY
EXCEPT WAGON
FUSE BLOCK
GRY WIRE
HOT AT ALL TIMES
HOT AT ALL TIMES PWR ST CIRCUIT BREAKER
HOT IN RUN
IGNITION
LEFT FRONT DOOR LOCK ACTUATOR
LEFT FRONT DOOR LOCK SWITCH
LEFT REAR DOOR LOCK ACTUATOR
LOCK
LOCK RELAY
LOCK UNLOCK
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
PARK SIGNAL UNLOCK OUTPUT/ INPUT
PNK WIRE
PNK/BLK WIRE
PROGRAM CONNECTOR
PROGRAM INPUT
REAR COMPARTMENT LID RELAY CONTROL
RELAY CONTROL
RIGHT FRONT DOOR LOCK ACTUATOR
RIGHT FRONT DOOR LOCK SWITCH
RIGHT REAR DOOR LOCK ACTUATOR
RR REL FUSE
STOP/HZD FUSE
STOPLAMP SWITCH
T/SIG FUSE
TAILGATE LOCK ACTUATOR
TAN WIRE
TRUNK,TAILGATE RELEASE SYSTEM
UNLOCK
UNLOCK RELAY
WAGON ONLY
WARNING SYSTEM
WHT WIRE
Go to component -> Power door locks circuit, with remote/keyless entry -> PROGRAM INPUT
