Buick Regal III (1988-1997) (engine harn, 8 cm from pcm break-out) wiring diagram
This page shows the only wiring diagram for the component.(engine harn, 8 cm from pcm break-out), which is found in the car Buick Regal III (1988-1997). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(engine harn, 8 cm from pcm break-out) wiring diagram (1 of 1)
1-2 CTRL SOL TCC PWM SOL
2-3 CTRL SOL
BLK WIRE
BLK/WHT WIRE
BRN WIRE
BRN/WHT WIRE
CRUISE FUSE
DATA LINK CONNECTOR (UNDER LEFT SIDE OF DASH)
DK BLU WIRE
ECM BATT FUSE
ECM IGN FUSE
ENGINE COOLANT TEMPERATURE SENSOR (TOP LEFT SIDE OF ENGINE)
FUSE 39
FUSE BLOCK
GRY WIRE
HOT AT ALL TIMES
HOT IN RUN
HOT IN RUN, BULB TEST OR START
INSTRUMENT CLUSTER
LT GRN WIRE
MALFUNCTION INDICATOR LAMP
NCA WIRE
ORG/ WIRE
PCM GROUND
PCM GROUND IGNITION IN PCM GROUND PNK WIRE
PNK WIRE
POWERTRAIN CONTROL MODULE (RIGHT SIDE OF ENGINE COMPT)
PPL
SECOND GEAR START SWITCH (PONTIAC ONLY)
SECOND GEAR START SWITCH INDIC LAMP (PONTIAC ONLY)
STOPLAMP/TORQUE CONVERTER CLUTCH SWITCH (BEHIND LEFT SIDE OF DASH)
TAN WIRE
TAN/BLK WIRE
TAN/WHT WIRE
TCC FUSE
TCC SOL
TFT SENSOR
THROTTLE POSITION SENSOR (THROTTLE BODY)
TRANS- AXLE
UNDERHOOD ELECTRICAL CENTER 1
VEHICLE SPEED SENSOR (LOWER RIGHT REAR OF ENGINE COMPT, ON TRANSAXLE)
WHT WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> 3.1l (vin m), transmission circuit -> (ENGINE HARN, 8 CM FROM PCM BREAK-OUT)
