Buick LaCrosse III (2016-2019) (engine harness, near breakout to map sensor) wiring diagram
This page shows the only wiring diagram for the component.(engine harness, near breakout to map sensor), which is found in the car Buick LaCrosse III (2016-2019). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(engine harness, near breakout to map sensor) wiring diagram (1 of 1)
BANK 1 SENSOR 2 HEATED OXYGEN SENSOR
BANK 2 SENSOR 2 HEATED OXYGEN SENSOR
BLK/BRN WIRE
BLK/GRN WIRE
BLK/LT GRN WIRE
BLK/VIO WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU/WHT WIRE
BODY CONTROL MODULE (UNDER FLOOR CONSOLE)
BRK APPLY
BRK APPLY SENS CTRL
BRK APPLY SENS SIG
BRN/GRY WIRE
BRN/WHT WIRE
CANISTER VENT SOL FUSE
COMPUTER DATA LINES SYSTEM
DK BLU WIRE
DK BLU/WHT WIRE
DK BLU/YEL WIRE
ECM IGN FUSE
FUEL TANK PRESSURE SENSOR
FUSE 9
GRY WIRE
GRY/RED WIRE
GRY/WHT WIRE
HI SPD GMLAN
HOT AT ALL TIMES
HOT W/ IGNITION MAIN RELAY ENERGIZED
INSTRUMENT PANEL FUSE BLOCK
LT GRN/WHT WIRE
MANIFOLD ABSOLUTE PRESSURE SENSOR
NCA WIRE
RED/BRN WIRE
SENS LOW REF
SERIAL DATA (-) (1)
UNDERHOOD FUSE BLOCK
VIO/DK BLU WIRE
VIO/LT GRN WIRE
WHT WIRE
WHT/BRN WIRE
WHT/DK BLU WIRE
WHT/RED WIRE
WHT/YEL WIRE
YEL/DK BLU WIRE
YEL/RED WIRE
YEL/WHT WIRE
Go to component -> Wiring diagram engine performance 3.6l vin s (3 of 9) -> (ENGINE HARNESS, NEAR BREAKOUT TO MAP SENSOR)
