Buick LaCrosse II facelift (2013-2016) engine start) Wiring diagram
This page shows the only wiring diagram for the component.engine start), which is found in the car Buick LaCrosse II facelift (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram engine start) (1 of 1)
2.4L HYBRID
3 25 GND HI SPEED GMLAN SERIAL DATA BUS -
3.6L
5-VOLT
ACCESSORY VOLT KEY CAPTURE/ COLUMN LOCK SHIFT POS SIG
BCM 2 (LOWER LEFT FUSE SIDE OF DASH)
BLK WIRE
BLK/BRN WIRE
BLK/YEL WIRE
BLU WIRE
BLU/YEL WIRE
BODY CONTROL MODULE (LEFT SIDE OF DASH)
BRAKE APPLY SENS LOW REF
BRAKE APPLY SENS SUPPLY VOLTAGE
BRAKE APPLY SENSOR SIGNAL
BRAKE PEDAL POSITION SENSOR (NEAR TOP OF ACCELERATOR
BRK POS
BRK POS SIG
COMPUTER DATA LINES SYSTEM
DK BLU WIRE
DLIS FUSE
ENGINE CONTROL MODULE (LEFT FRONT OF ENGINE COMPT)
ENGINE START)
GROUND DISTRIBUTION SYSTEM
HI SPEED GMLAN
HI SPEED GMLAN SERIAL DATA BUS -
HOT AT ALL TIMES
HYBRID/EV BATTERY PACK (RIGHT SIDE OF LUGGAGE COMPT)
HYBRID/EV POWERTRAIN CONTROL MODULE
IGNITION SWITCH
INSTRUMENT PANEL FUSE BLOCK
KEY CAPTURE SOLENOID ACTUATOR
KEY-IN IGNITION SWITCH
LOW REF
OFF
OFF/RUN/CRANK VOLT
PARK POSITION SWITCH
PEDAL ASSEMBLY)
RED/BLU WIRE
RED/BRN WIRE
RUN WIRE
SNSR SIG
STARTER/GENERATOR CONTROL MODULE
TRANSMISSION SHIFT LEVER (W/ KEYLESS
VIO/YEL WIRE
WHT WIRE
WHT/GRN WIRE
WHT/RED WIRE
WHT/VIO WIRE
Go to component -> Ignition lock solenoid circuit -> ENGINE START)
