Buick LaCrosse II facelift (2013-2016) (bumper harness, 10 mm from breakout to left middle rear object sensor) wiring diagram
This page shows the only wiring diagram for the component.(bumper harness, 10 mm from breakout to left middle rear object sensor), which is found in the car Buick LaCrosse II facelift (2013-2016). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(bumper harness, 10 mm from breakout to left middle rear object sensor) wiring diagram (1 of 1)
1 2 3 4 5 6 7 8 LEFT REAR CORNER OBJECT SENSOR LEFT REAR MIDDLE OBJECT SENSOR
1 2 3 4 5 6 7 B+
8 9 10 11 12 REAR PARK ASSIST DISABLE SIGNAL
BLK WIRE
BLK/GRY WIRE
BODY CONTROL MODULE (LEFT SIDE OF DASH)
BRN/WHT WIRE
COMPUTER DATA LINES SYSTEM
DIM CTRL
GRN WIRE
GRN/BRN WIRE
GRY WIRE
GRY/GRN WIRE
HOT AT ALL TIMES
INSTRUMENT PANEL MULTI-FUNCTION SWITCH 2
LEFT MIDDLE REAR OBJECT SENSOR (LEFT SIDE OF REAR BUMPER)
LEFT OUTER REAR OBJECT SENSOR (LEFT SIDE OF REAR BUMPER)
LOW REFERENCE
LOW SPEED GMLAN SERIAL DATA GROUND
OBST DETCT FUSE
PARKING ASSIST CONTROL MODULE (CENTER OF REAR PACKAGE SHELF)
PARKING ASSIST ON/OFF SWITCH
RED/GRN WIRE
RIGHT MIDDLE REAR OBJECT SENSOR (RIGHT SIDE OF REAR BUMPER)
RIGHT OUTER REAR OBJECT SENSOR
SUPPLY VOLT
UNDERHOOD FUSE BLOCK (LEFT SIDE OF BATTERY)
WHT WIRE
YEL WIRE
YEL/BLU WIRE
YEL/VIO WIRE
YEL/WHT WIRE
Go to component -> Parking assistant circuit -> (BUMPER HARNESS, 10 MM FROM BREAKOUT TO LEFT MIDDLE REAR OBJECT SENSOR)
