Buick LaCrosse II (2009-2013) w/ keyless engine Wiring diagrams
This page contains all the electrical diagrams for the component. w/ keyless engine, in which he is found in the car Buick LaCrosse II (2009-2013). You can view various wiring diagrams where this component is used, as well as go to more detailed diagrams to see the complete connection and interaction in the system. All diagrams have links to quickly jump to the corresponding section with the component for easy viewing..
Wiring diagram w/ keyless engine (1 of 2)
2.4L
3.6L
3.6L EXCEPT
AUTOMATIC TRANSMISSION ASSEMBLY CONTROL SOLENOID VALVE ASSEMBLY
BLK WIRE
BLK/ WHT WIRE
BLK/WHT WIRE
BLU WIRE
BRAKE FLUID LEVEL SWITCH
DATA LINK CONNECTOR
ENGINE CONTROL MODULE
EXCEPT 2.4L
EXCEPT 3.6L
HVAC CONTROL MODULE
IGNITION COIL 1
IGNITION COIL 2
IGNITION COIL 3
IGNITION COIL 4
INSTRUMENT CLUSTER
LEFT FRONT STRUT TOWER)
LEFT REAR DOOR COURTESY LAMP
LEFT REAR DOOR LATCH ASSEMBLY
LEFT REAR DOOR LEFT REAR ACCENT DOOR HANDLE LAMP ACCENT LAMP
LEFT REAR WINDOW SWITCH
MASS AIR FLOW/ INTAKE AIR TEMPERATURE SENSOR
MULTI-AXIS ACCELERATION SENSOR
NCA WIRE
OUTSIDE REARVIEW MIRROR SWITCH
PASSENGER DOOR LATCH ASSEMBLY
PASSENGER DOOR PASSENGER HANDLE DOOR ACCENT ACCENT LAMP LAMP
PASSENGER SEATBACK AUDIO VIDEO DISPLAY AMPLIFIER
PASSENGER WINDOW SWITCH
RIGHT REAR DOOR HANDLE ACCENT LAMP
RIGHT REAR DOOR LATCH ASSEMBLY
RIGHT REAR RIGHT REAR DOOR DOOR COURTESY ACCENT LAMP LAMP
STARTER
STEERING WHEEL ANGLE SENSOR
SWITCH) IGNITION MODE SWITCH
TELEMATICS COMMUNICATION DRIVE INTERFACE SEATBACK CONTROL MODULE VIDEO DISPLAY
TO WINDSHIELD WIPER MOTOR CONNECTOR)
TRANSMISSION SHIFT LEVER POSITION INDICATOR
TURN SIGNAL/ HEADLAMP MULTI-FUNCTION SWITCH SWITCH
W/ AMPLIFIER W/ ONSTAR, W/O ONSTAR AMPLIFIER
W/ AMPLIFIER W/ W/O ONSTAR, ONSTAR AMPLIFIER
W/ KEYLESS ENGINE
W/ MEMORY
W/ ONSTAR
W/ ONSTAR W/O AMPLIFIER
W/ W/ ONSTAR ONSTAR, W/O AMPLIFIER AMPLIFIER
W/O MEMORY
WHT/ BLK WIRE
WINDSHIELD WIPER
WINDSHIELD WIPER MOTOR
WIPER WIPER RELAY RELAY DIODE 1 DIODE 2
Go to component -> Ground distribution circuit (2 of 4) -> W/ KEYLESS ENGINE
Wiring diagram w/ keyless engine (2 of 2)
ACCESSORY VOLT
BLK WIRE
BODY CONTROL MODULE (LEFT SIDE OF DASH)
BRAKE APPLY SENS LOW REF
BRAKE APPLY SENS SUPPLY VOLTAGE
BRAKE APPLY SENSOR SIGNAL
BRAKE PEDAL POSITION SENSOR (NEAR TOP OF ACCELERATOR PEDAL ASSEMBLY)
COMPUTER DATA LINES
DK BLU WIRE
FUSE
HI SPEED GMLAN SERIAL DATA BUS -
HOT AT ALL TIMES
INSTRUMENT PANEL FUSE BLOCK (LOWER LEFT SIDE OF DASH)
KEY CAPTURE SOLENOID ACTUATOR (W/O KEYLESS ENGINE START SWITCH)
KEY CAPTURE/ COLUMN LOCK SHIFT POSITION SIG
PARK POSITION SWITCH
RED/BRN WIRE
SWITCH
SYSTEM
TRANSMISSION SHIFT LEVER
VIO/YEL WIRE
W/ KEYLESS ENGINE
W/O KEYLESS ENGINE
WHT WIRE
WHT/VIO WIRE
Go to component -> Ignition lock solenoid circuit -> W/ KEYLESS ENGINE
