Buick Century VI (1997-2005) ign key resistor pellet Wiring diagram
This page shows the only wiring diagram for the component.ign key resistor pellet, which is found in the car Buick Century VI (1997-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram ign key resistor pellet (1 of 1)
BCM GND
BCM PWR FUSE
BLK WIRE
BODY CONTROL MODULE (BEHIND LEFT SIDE OF DASH, LEFT OF STEERING COLUMN)
CLUSTER FUSE
CRANK RELAY II
CRANK SIGNAL BCM, CLUSTER FUSE
CRANK VOLTAGE PPL
DATA LINK CONNECTOR (DLC) (UNDER LEFT SIDE OF DASH, RIGHT OF STEERING COLUMN)
DK GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN
HOT IN OFF, RUN OR START
HOT IN RUN OR START
HOT IN RUN, BULB TEST OR START
I/P FUSE BLOCK
IGN
IGN 0: CLUSTER PCM, BCM FUSE
IGN KEY RESISTOR PELLET
IGN KEY SIG
IGN REF LO
IGNITION SWITCH
INSTRUMENT PANEL CLUSTER
KEY IN KEY OUT
KEY-IN SIG
LT GRN WIRE
ORG/ WIRE
PASS-KEY ENABLE SWITCH
PCM BCM IGN RELAY FUSE
PNK WIRE
PPL
PPL IGN (0)
PPL/WHT WIRE
SECURITY INDICATOR
SERIAL DATA
STARTER RLY CTRL
STARTER SOLENOID
TAN WIRE
UNDERHOOD FUSE BLOCK (MOUNTED TO RIGHT STRUT TOWER)
WHT WIRE
WHT/BLK WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> Anti-theft circuit -> IGN KEY RESISTOR PELLET
