Buick Century VI (1997-2005) gen terminal l output Wiring diagram
This page shows the only wiring diagram for the component.gen terminal l output, which is found in the car Buick Century VI (1997-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram gen terminal l output (1 of 1)
1-2 SHIFT SOLENOID
1174 85 CRUISE CONTROL SYSTEM
2-3 SHIFT SOLENOID
444 472 (PIN 47-48 NOT USED)
5 VOLT REF (PIN 31-32 NOT USED) 33 34 35 36 37 38 39 TPS REF TP SWITCH
AIR CONDITIONING SYSTEM
AUTO TRANSAXLE FLUID TEMPERATURE AUTOMATIC TRANSMISSION SENSOR
BLK WIRE
BLK/WHT WIRE
BRN WIRE
BRN/WHT WIRE
CLUSTER FUSE
CRANK SIGNAL FUSE
DK BLU WIRE
DK GRN WIRE
DK GRN/WHT WIRE
ENG OIL LEVEL IND IN CRUISE STATUS
EVAP CAN VENT SOL CONTROL FUEL PUMP RELAY CONTROL EGR VAL CONTROL MIL CONTROL
F/PMP RELAY
FUEL PUMP
FUEL PUMP PRIME CONNECTOR
FUEL TANK
GEN TERMINAL L OUTPUT
GRY WIRE
GRY/BLK WIRE
HEATED OXYGEN SENSOR 1
HEATED OXYGEN SENSOR 2
HOT AT ALL TIMES F/PMP FUSE 35
HOT IN
HOT IN RUN, BULB TEST OR START
IAC COIL "A" LOW
IAC COIL A HIGH (PIN 8-9 NOT USED) PPL 10 11
IAC COIL B LOW IAT SENSOR SIGNAL
LT BLU/BLK WIRE
LT BLU/WHT WIRE
LT GRN WIRE
LT GRN/BLK WIRE
NCA WIRE
PNK WIRE
PPL
PPL FUEL LEVEL SENSOR
PPL/WHT WIRE
RED WIRE
RED/BLK WIRE
RED/WHT WIRE
SENSOR GROUND
STARTING/ CHARGING SYSTEM
TAN WIRE
TAN/BLK WIRE
TAN/WHT WIRE
TCC PWM SOL VAL CONTROL
TCC SOLENOID VALVE
TFT SENSOR SIGNAL FUEL LEVEL SENSOR INPUT CKP SENS PPL
TR SWITCH INPUT A ENG OIL PRESS SWITCH IN
TRANS FUSE 26 OXY SEN FUSE 29
UNDERHOOD FUSE BLOCK (MOUNTED TO RIGHT STRUT TOWER)
WHT WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> Wiring diagram engine performance 3.1l vin j (4 of 4) -> GEN TERMINAL L OUTPUT
