BMW 7 series E38 (1994-1998) standby ind Wiring diagram
This page shows the only wiring diagram for the component.standby ind, which is found in the car BMW 7 series E38 (1994-1998). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram standby ind (1 of 1)
BLK WIRE
BLK/YEL WIRE
BLK/YEL/WHT WIRE
BLU WIRE
BLU/GRY WIRE
BLU/WHT WIRE
BRN WIRE
BRN/BLK WIRE
BRN/BLK/WHT WIRE
BRN/ORG WIRE
CYL 1-6 ELECTRONIC THROTTLE POSITION ACTUATOR (LEFT FRONT OF ENGINE)
CYL 7-12 ELECTRONIC THROTTLE POSITION ACTUATOR (RIGHT SIDE OF ENGINE)
ENGINE ELECTRONICS FUSE CARRIER
FUSE 4
GRN WIRE
GRN/WHT WIRE
GROUND
GROUND POT 1
GROUND POT 2
GRY WIRE
GRY/GRN WIRE
GRY/WHT WIRE
HOT AT ALL TIMES
INSTRUMENT CLUSTER
LIGHT MODULE
MOTOR 1
MOTOR 2
RED WIRE
RED/WHT WIRE
RED/WHT/YEL WIRE
SENSOR 1
SENSOR 2
SHIELD
SHIELD SHIELD
SHIELD SHIELD POT 2 SHIELD POT 1 SHIELD
STANDBY IND
VIO WIRE
VIO/WHT WIRE
YEL WIRE
YEL/RED WIRE
YEL/RED/WHT WIRE
Go to component -> Wiring diagram engine performance 5.4l, electronic throttle control circuit (1 of 2) -> STANDBY IND
