BMW 1 series E81/E82/E87/E88 facelift 2 (2011-2014) jump start terminal point (right side of engine compat) wiring diagram
This page shows the only wiring diagram for the component.jump start terminal point (right side of engine compat), which is found in the car BMW 1 series E81/E82/E87/E88 facelift 2 (2011-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
jump start terminal point (right side of engine compat) wiring diagram (1 of 1)
BLK/BLU WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLU/RED WIRE
BLU/WHT WIRE
BLU/YEL WIRE
BRN WIRE
CHARACTERISTIC MAP THERMOSTAT
COMPUTER DATA LINES SYSTEM
ELECTRIC FUEL PUMP
ENGINE BREATHER HEATER 1
EXHAUST VANOS SOLENOID VALVE (FRONT OF ENGINE)
FUEL PUMP CONTROL (EKPS)
FUEL TANK VENT VALVE
FUSE 102 HOLDER (RIGHT SIDE OF REAR COMPT)
GRN/RED WIRE
HOT AT ALL TIMES
HOT W/
IGNITION, FUEL INJECTION RELAY
INTAKE VANOS SOLENOID VALVE (FRONT OF ENGINE)
JUMP START TERMINAL POINT (RIGHT SIDE OF ENGINE COMPAT)
NCA WIRE
OIL PRESSURE CONTROL VALVE
OXYGEN SENSOR AFTER CATALYTIC CONVERTER
REAR FUSE
RED WIRE
RED/BLK WIRE
RED/GRN WIRE
RED/WHT WIRE
RELAY ENERGIZED JUNCTION BOX (UNDER RIGHT OF DASH) FUSE 70
THRUST AIR CONTROL VALVE
WHT WIRE
WHT/BLU WIRE
WHT/GRY WIRE
YEL WIRE
YEL/BLU WIRE
YEL/RED WIRE
Go to component -> Wiring diagram engine performance 3.0l twin turbo (2 of 5) -> JUMP START TERMINAL POINT (RIGHT SIDE OF ENGINE COMPAT)
