BMW 1 series E81/E82/E87/E88 facelift 2 (2011-2014) intake pipe pressure sensor Wiring diagram
This page shows the only wiring diagram for the component.intake pipe pressure sensor, which is found in the car BMW 1 series E81/E82/E87/E88 facelift 2 (2011-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram intake pipe pressure sensor (1 of 1)
BLK/BLU WIRE
BLK/GRN WIRE
BLK/RED WIRE
BLK/VIO WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU WIRE
BLU/YEL WIRE
COOLING FANS SYSTEM
CRANKSHAFT SENSOR
DME CONTROL MODULE (RIGHT REAR OF ENGINE COMPT)
ELECTRIC THROTTLE VALVE ACTUATOR
INTAKE AIR TEMPERATURE/ BOOT PRESSURE SENSOR
INTAKE PIPE PRESSURE SENSOR
KNOCK SENSOR CYLINDERS CYLINDERS 1-3 4-6
NCA WIRE
OIL CONDITION SENSOR (REAR OF ENGINE, NEAR TRANSMISSION)
ORG/ WIRE
OXYGEN SENSOR BEFORE CATALYTIC CONVERTER
RED/GRN WIRE
STARTING/CHARGING SYSTEM
VIO WIRE
VOLUME CONTROL VALVE
WHT WIRE
WHT/BLU WIRE
WHT/GRN WIRE
WHT/GRY WIRE
WHT/YEL WIRE
YEL WIRE
YEL/BLU WIRE
YEL/RED WIRE
YEL/WHT WIRE
Go to component -> Wiring diagram engine performance 3.0l twin turbo (1 of 5) -> INTAKE PIPE PRESSURE SENSOR
