Audi TT 8J facelift (2010-2014) haldex clutch control valve Wiring diagram
This page shows the only wiring diagram for the component.haldex clutch control valve, which is found in the car Audi TT 8J facelift (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram haldex clutch control valve (1 of 1)
2.5L
2.OL CDMA
2.OL CETA
ALL- WHEEL DRIVE CONTROL MODULE
BLK WIRE
BLK/BLU WIRE
BLK/RED WIRE
BLK/YEL WIRE
BRAKE LIGHT, BRAKE PEDAL SWITCH (ON BRAKE MASTER CYLINDER)
BRN WIRE
COMPUTER DATA LINES SYSTEM
ENGINE CONTROL MODULE (ECM) (EXCEPT 2.5L: CENTER REAR OF ENGINE COMPT)
ENGINE CONTROLS SYSTEM
FUSE 8 FUSE 2
FUSE PANEL SC (LEFT SIDE OF DASH)
GRY WIRE
HALDEX CLUTCH CONTROL VALVE
HALDEX CLUTCH PUMP
HOT W/ POWER SUPPLY RELAY 2 (TERMINAL 15) ENERGIZED
NCA WIRE
OIL PRESSURE/ TEMPERATURE SENSOR
ORG/BLK WIRE
ORG/BRN WIRE
POWER DISTRIBUTION SYSTEM
WHT/GRN WIRE
YEL WIRE
YEL/BLK WIRE
Go to component -> Awd circuit -> HALDEX CLUTCH CONTROL VALVE
