Audi Q3 II (2018-2024) (inside driver rear wheel housing, behind sill trim) wiring diagram
This page shows the only wiring diagram for the component.(inside driver rear wheel housing, behind sill trim), which is found in the car Audi Q3 II (2018-2024). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(inside driver rear wheel housing, behind sill trim) wiring diagram (1 of 1)
AIR BAG CONTROL MODULE
BLK WIRE
BLK/WHT WIRE
BLU WIRE
BOTTOM COUPLING POINT ON LEFT A-PILLAR
BRN WIRE
BRN/YEL WIRE
COMPUTER DATA LINES SYSTEM
DRIVER FRONT AIR BAG CRASH SENSOR
DRIVER HEAD CURTAIN AIR BAG IGNITER
DRIVER SEAT BELT
DRIVER SEAT COUPLING POINT
DRIVER SIDE REAR SEAT BELT TENSIONER IGNITER
DRIVER SIDE REAR THORAX AIR BAG CRASH SENSOR
DRIVER THORAX AIR BAG CRASH SENSOR
DRIVER THORAX AIR BAG IGNITER
FORCE LIMITER
FRONT PASSENGER THORAX AIR BAG CRASH SENSOR
FUSE 13
FUSE 33
FUSE 41
FUSE PANEL C
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT W/ TERMINAL 15 POWER SUPPLY RELAY ENERGIZED
IGNITER 1
LEFT FRONT DOOR COUPLING POINT
ORG/BRN WIRE
PASSENGER SIDE FRONT AIR BAG CRASH SENSOR
PASSENGER SIDE REAR THORAX AIR BAG CRASH SENSOR
RED WIRE
RED/BLU WIRE
RIGHT FRONT DOOR COUPLING POINT
STEERING COLUMN ELECTRONICS CONTROL MODULE
TENSIONER CONTROL MODULE
VIO WIRE
VIO/WHT WIRE
WHT WIRE
WHT/RED WIRE
YEL WIRE
Go to component -> Supplemental restraints circuit (1 of 3) -> (INSIDE DRIVER REAR WHEEL HOUSING, BEHIND SILL TRIM)
