Alfa Romeo Stelvio I (2017-2024) switch output Wiring diagram
This page shows the only wiring diagram for the component.switch output, which is found in the car Alfa Romeo Stelvio I (2017-2024). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram switch output (1 of 1)
2.0L TURBO
2.9L TURBO
BATTERY DISTRIBUTION UNIT
BLK WIRE
BODY CONTROL MODULE
BRAKE LAMP
BRAKE PAD
BRAKE PAD WEAR
BRAKE SIGNAL 1
CENTER HIGH MOUNTED STOP LAMP
CIRCUIT BOARD
DIMMER SWITCH
DK BLU/BLK WIRE
ELECTRIC PARKING BRAKE MODULE
FUSE 36
FUSE 42
FUSE 72
FUSED B (+)
GRN WIRE
GRN/ORG WIRE
GRN/WHT WIRE
GRY/GRN WIRE
HOT AT ALL TIMES
IGNITION RUN/
LEFT FRONT BRAKE PAD SENSOR
LEFT REAR BRAKE PAD SENSOR
LUGGAGE COMPT FLOOR)
MUX
OFF
PANEL LAMPS
POWERTRAIN CONTROL MODULE
POWERTRAIN CONTROL MODULE 2
RADIO FREQUENCY HUB MODULE
RED WIRE
RED/GRN WIRE
RIGHT FRONT BRAKE PAD SENSOR
RIGHT REAR BRAKE PAD SENSOR
SIGNAL
START OUTPUT
SWITCH OUTPUT
VIO/DK BLU WIRE
VIO/GRN WIRE
VIO/GRY WIRE
VIO/ORG WIRE
VIO/RED WIRE
VIO/WHT WIRE
WEAR SIGNAL
WHT/GRY WIRE
YEL WIRE
Go to component -> Anti-lock brakes circuit (2 of 2) -> SWITCH OUTPUT
