Acura TSX II (2008-2014) eps torque sensor Wiring diagram
This page shows the only wiring diagram for the component.eps torque sensor, which is found in the car Acura TSX II (2008-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram eps torque sensor (1 of 1)
2.4L 3.5L
3.5L
BLK WIRE
BLU WIRE
BRN WIRE
CAN L
CAN-H
CIRCUIT/ CONTROLLER AREA NETWORK CONTROLLER
COMPUTER DATA LINES SYSTEM
CONTROL CIRCUITS
DLC IN/OUT (K-LINE)
DRIVER'S JUNCTION BOX 1 (UNDER LEFT SIDE OF DASH)
DRIVER'S UNDER-DASH FUSE/RELAY BOX (BEHIND LEFT KICK PANEL)
ECM/PCM (2.4L) PCM (3.5L) (LEFT SIDE OF ENGINE COMPT)
ENG SPD PULSE
EPS CONTROL UNIT (UNDER RIGHT SIDE OF DASH)
EPS IND
EPS MOTOR
EPS MOTOR ANGLE SENSOR
EPS TORQUE SENSOR
FAST CONTROLLER AREA NETWORK TRANSCEIVER
FUSE 5
FUSE 6
GAUGE CONTROL MODULE
GRN WIRE
HOT AT ALL TIMES
HOT IN ON OR START
LT BLU WIRE
LT GRN WIRE
MU MV
MULTI- FUSE 2 EPS FUSE
ORG/ WIRE
PNK PNK WIRE
PNK WIRE
PWR GND (PG) BATT IN (B+)
RED WIRE
REF VOLT (PVF) PNK WIRE
SER CHK (SCS)
STEERING GEARBOX
UNDER-HOOD FUSE/RELAY BOX (LEFT REAR OF ENGINE COMPT)
WARNING DRIVE CIRCUIT
WHT WIRE
YEL WIRE
Go to component -> Electronic power steering circuit -> EPS TORQUE SENSOR
