Acura TL IV facelift (2011-2014) eps torque sensor Wiring diagram
This page shows the only wiring diagram for the component.eps torque sensor, which is found in the car Acura TL IV facelift (2011-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram eps torque sensor (1 of 1)
AREA NETWORK
BLK WIRE
BLU WIRE
BRN WIRE
CAN-L PPL
CENTER JUNCTION BOX (UNDER LEFT SIDE OF DASH)
COMPUTER DATA LINES SYSTEM
CONTROL CIRCUITS
CONTROLLER
DRIVER'S JUNCTION BOX 1 (BEHIND LEFT SIDE OF DASH)
DRIVER'S UNDER-DASH FUSE/RELAY BOX (UNDER LEFT END OF DASH)
ECM/PCM (RIGHT SIDE OF ENGINE COMPT)
EPS CONTROL UNIT (UNDER RIGHT SIDE OF DASH)
EPS IND
EPS MOTOR
EPS MOTOR ANGLE SENSOR
EPS TORQUE SENSOR
FAST
FUSE 12
FUSE 6
GAUGE CONTROL MODULE
GROUND BATT IN (B+) MW
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
K LINE
LT BLU WIRE
MU MV CAN-H
MULTI- FUSE 2 EPS FUSE
NEP
ORG/ WIRE
PASSENGER'S UNDER- DASH FUSE/RELAY BOX (BEHIND RIGHT KICK PANEL)
PNK 10 11 12 4 5 6 WIRE
PNK WIRE
PPL
PVF
RED WIRE
SCS
STEERING ANGLE SENSOR (W/ SH-AWD) (ON STEERING COLUMN)
STEERING GEARBOX
TRANSCEIVER/
UNDER-HOOD FUSE/RELAY BOX (LEFT REAR OF ENGINE COMPT)
VSA MODULATOR CONTROL UNIT (RIGHT SIDE OF ENGINE COMPT)
WHT WIRE
YEL WIRE
Go to component -> Electronic power steering circuit -> EPS TORQUE SENSOR
