Acura TL IV (2008-2011) warning driver circuit wiring diagram
This page shows the only wiring diagram for the component.warning driver circuit, which is found in the car Acura TL IV (2008-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
warning driver circuit wiring diagram (1 of 1)
BLK WIRE
BLU WIRE
BRAKE PEDAL POSITION SWITCH (ON BRAKE PEDAL MOUNTING BRACKET)
BRN WIRE
CABLE REEL (IN STEERING COLUMN)
COMPUTER DATA LINES SYSTEM
CRUISE CONTROL COMBINATION/SELECT/RESET INFORMATION SWITCH
CRUISE CONTROL IND
CRUISE CONTROL MAIN SWITCH
CRUISE CONTROL MAIN SWITCH IND
DIMMING CIRCUIT INDICATOR
DRIVER'S JUNCTION BOX 1 (BEHIND LEFT SIDE OF DASH)
DRIVER'S MICU
DRIVER'S UNDER-DASH FUSE/RELAY BOX (UNDER LEFT END OF DASH)
FAST CONTROLLER
FUSE
FUSE FUSE 12
GAUGE CONTROL MODULE
GRN WIRE
GRY WIRE
HORN RELAY
HORN SWITCH
HORNS SYSTEM
HOT AT ALL TIMES
HOT AT ALL TIMES UNDER-HOOD FUSE/RELAY BOX FUSE (LEFT REAR OF ENGINE COMPT)
HOT IN ON OR START
LT BLU WIRE
LT GRN WIRE
NEXT SWITCH
ORG/ WIRE
RED WIRE
RESUME/ ACCEL CANCEL SWITCH SWITCH
RIGHT END OF DASH)
SELECT/ RESET PREVIOUS SWITCH SWITCH
SET/ DECEL
STABILIZER CIRCUIT
STEERING WHEEL)
SWITCH
TRANSCEIVER AREA NETWORK
TRANSMISSIONS SYSTEM
WARNING DRIVER CIRCUIT
WHT WIRE
YEL WIRE
Go to component -> Cruise control circuit (2 of 2) -> WARNING DRIVER CIRCUIT
