Acura TL III facelift (2006-2008) signal input Wiring diagram
This page shows the only wiring diagram for the component.signal input, which is found in the car Acura TL III facelift (2006-2008). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram signal input (1 of 1)
ATP-P
BLK WIRE
BLU WIRE
BLU/BLK WIRE
BRAKE PEDAL POSITION SWITCH (NEAR BRAKE PEDAL)
CANADA
DRIVE INPUT
FUSE 13
FUSE 32 MICU
GAUGE CONTROL MODULE
HOT AT ALL TIMES
HOT IN ACC OR ON
IG KEY SW
IGNITION KEY SWITCH
IGNITION KEY SWITCH/KEY LIGHT
IMOES UNIT
JUNCTION CONNECTOR
KEY INTERLOCK SOLENOID
KEY SOL
LEFT END OF DASH)
P-PIN
PCM (BEHIND CENTER OF DASH)
RED WIRE
SEDF
SHIFT LOCK SOLENOID (UNDER CENTER CONSOLE)
SHIFT LOCK SOLENOID INPUT
SIGNAL INPUT
STOP SW
SWITCH INPUT
THROTTLE ACTUATOR CONTROL MODULE (BEHIND GLOVE BOX)
TRANSMISSION GEAR SELECTION
TRANSMISSION RANGE SWITCH (ON TRANSAXLE
UNDER-DASH FUSE/RELAY BOX (BEHIND
UNDER-HOOD FUSE/RELAY BOX (LEFT REAR OF ENGINE COMPT)
WHT WIRE
WHT/BLK WIRE
YEL WIRE
YEL/BLK WIRE
YEL/BLU WIRE
Go to component -> Shift interlock circuit, a/t -> SIGNAL INPUT
