Acura RL II facelift (2008-2012) seat belt switch wiring diagram
This page shows the only wiring diagram for the component.seat belt switch, which is found in the car Acura RL II facelift (2008-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
seat belt switch wiring diagram (1 of 1)
"B" PILLAR) LT
B-CAN
B-CAN KEY LT
BEEPER
BLK WIRE
BLU WIRE
BLU/YEL WIRE
BODY CONTROLLER AREA NETWORK TRANSCEIVER
BRN WIRE
COMBINATION LIGHT SWITCH
COMBINATION SWITCH CONTROL UNIT
COMPUTER CANH CANL SWITCH INPUT DATA LINES SYSTEM (OPSVU)
DOOR SW (DR)
DRIVE CIRCUIT
DRIVER'S DOOR SWITCH
DRIVER'S MPCS UNIT (IN DRIVER'S DOOR)
DRIVER'S SEAT BELT BUCKLE SWITCH (UNDER DRIVER'S SEAT)
DRIVER'S SEAT BELT TENSION REDUCER
DRIVER'S UNDER-DASH FUSE/RELAY BOX (BEHIND LEFT KICK PANEL)
FUSE
GAUGE CONTROL MODULE
GRN WIRE
HEAD AUTO PARK
HEADLIGHT SWITCH
HOT AT ALL TIMES
HOT IN ON OR START
IGNITION KEY LIGHT
IGNITION KEY SWITCH
IGNITION SWITCH CONTROL UNIT
J/C
KEY SW
KEYLESS ACCESS CONTROL UNIT (UNDER LEFT SIDE OF DASH)
LBSC LBSD
LEFT REAR DOOR LOCK ACTUATOR/KNOB SWITCH/DOOR SWITCH (REAR OF LEFT REAR DOOR)
LIGHTS ON IND
LOW OIL PRESSURE IND
LT GRN WIRE
MICU
OFF
OIL PRESSURE SWITCH (RIGHT SIDE OF ENGINE)
ORG/ WIRE
PCM (UNDER MIDDLE OF DASH)
PNK WIRE
POWER SUPPLY CIRCUIT/ CONTROLLER AREA NETWORK CONTROLLER
RED WIRE
RED/BLK WIRE
REGULATOR
SEAT BELT REMINDER IND
SEAT BELT SWITCH
SG-1
SG-2
SOLENOID (ON BASE OF LEFT "B" PILLAR)
SRS UNIT (UNDER LOWER MIDDLE OF DASH)
WHT WIRE
WIPER/WASHER SWITCH
YEL WIRE
YEL/RED WIRE
Go to component -> Chime circuit -> SEAT BELT SWITCH
