Acura RL II facelift (2008-2012) network controller power supply circuit/controller area Wiring diagram
This page shows the only wiring diagram for the component.network controller power supply circuit/controller area, which is found in the car Acura RL II facelift (2008-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram network controller power supply circuit/controller area (1 of 1)
APP SENSOR (UNDER LEFT SIDE OF DASH)
APSB
BLK WIRE
BLU WIRE
BLU/RED WIRE
BLU/YEL WIRE
BRN WIRE
COMPUTER DATA LINES SYSTEM
CRUISE CONTROL MAIN SWITCH INDICATOR
DIMMING CIRCUIT CRUISE CONTROL
DRIVE CIRCUIT
DRIVER'S UNDER-DASH FUSE/RELAY BOX (BEHIND LEFT KICK PANEL)
FUSE 21
FUSE 7
GAUGE CONTROL MODULE
GRN WIRE
GRN/WHT WIRE
GRN/YEL WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
LT GRN WIRE
MRLY ETCS RLY BKSWNC BKSW ATP-FWD NC
NETWORK CONTROLLER POWER SUPPLY CIRCUIT/CONTROLLER AREA
NETWORK TRANSCEIVER FAST CONTROLLER AREA
PCM (UNDER MIDDLE OF DASH)
PNK WIRE
PPL
PPL APSA
RED WIRE
RED/BLK WIRE
RED/BLU WIRE
REGULATOR
SEDF
SEDF SEFD
SEFD GND
THROTTLE ACTUATOR CONTROL MODULE (BEHIND RIGHT KICK PANEL)
TOP OF TRANSMISSION)
TP SENSOR/THROTTLE ACTUATOR (ON THROTTLE BODY)
VCC
WARNING
WHT WIRE
YEL/GRN WIRE
YEL/RED WIRE
Go to component -> Cruise control circuit (1 of 2) -> NETWORK CONTROLLER POWER SUPPLY CIRCUIT/CONTROLLER AREA
