Acura RL II (2004-2008) wind- shield wiper motor relay Wiring diagram
This page shows the only wiring diagram for the component.wind- shield wiper motor relay, which is found in the car Acura RL II (2004-2008). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram wind- shield wiper motor relay (1 of 1)
B-CAN
BLK WIRE
BLU WIRE
COMBINATION SWITCH CONTROL UNIT
CONTROL BLOCK
DRIVER'S UNDER-DASH FUSE/RELAY BOX (BEHIND LEFT KICK PANEL)
FUSE 11
FUSE 21
FUSE 7
FUSE 9
GAUGE CONTROL MODULE
GRN WIRE
HOT AT ALL TIMES
HOT IN ON OR START
INT LOW OFF HIGH MIST
INT OFF LOW MIST HIGH
INTERMITTENT DWELL TIME CONTROLLER
INTERMITTENT WIPER RELAY
J/C
LT GRN WIRE
MICU
OF WASHER RESERVOIR)
OFF WASH
PARK
PNK WIRE
POWER SUPPLY CIRCUIT/ CONTROLLER AREA NETWORK CONTROLLER
RED WIRE
RELAY CONTROL MODULE
RUN WIRE
UNDER-HOOD FUSE/RELAY BOX (LEFT REAR OF ENGINE COMPT)
VBU
WASHER FLUID LEVEL SWITCH
WASHER MOTOR RELAY
WHT WIRE
WIND- SHIELD WIPER MOTOR RELAY
WINDSHIELD WASHER MOTOR (IN BOTTOM
WINDSHIELD WIPER HIGH RELAY
WINDSHIELD WIPER MOTOR (IN LEFT REAR OF ENGINE COMPT, UNDER COWL COVER)
WIPER/ WASHER SWITCH
YEL WIRE
Go to component -> Front wiper/washer circuit -> WIND- SHIELD WIPER MOTOR RELAY
