Acura RDX II (2013-2015) power supply circuit/controller Wiring diagram
This page shows the only wiring diagram for the component.power supply circuit/controller, which is found in the car Acura RDX II (2013-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram power supply circuit/controller (1 of 1)
AREA NETWORK CONTROLLER
BLK WIRE
BLU WIRE
BRN WIRE
CENTER JUNCTION BOX 2
COMPUTER DATA LINES SYSTEM
F-CAN
F-CAN H
F-CAN L
FUSE
FUSE 29
GAUGE CONTROL MODULE
GRN WIRE
HOT AT ALL TIMES
HOT AT ALL TIMES UNDER-HOOD FUSE/RELAY BOX (LEFT REAR
HOT IN ON OR START
INDICATOR DRIVE CIRCUIT
LEFT FRONT TPMS INITIATOR (AT LEFT FRONT WHEEL WELL)
LEFT REAR TPMS INITIATOR (AT LEFT REAR WHEEL WELL)
LOW TIRE PRESSURE IND
LT BLU WIRE
MULTI-INFORMATION DISPLAY
OF ENGINE COMPT)
ORG/ WIRE
PNK 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 WIRE
PNK WIRE
POWER SUPPLY CIRCUIT/CONTROLLER
PPL
PPL PNK WIRE
RED WIRE
RIGHT FRONT TPMS INITIATOR (AT RIGHT FRONT WHEEL WELL)
RIGHT REAR TPMS INITIATOR (AT RIGHT REAR WHEEL WELL)
SYSTEM MESSAGE IND
TPMS CONTROL UNIT (BELOW LEFT SIDE OF DASH)
TRANSCEIVER/
UNDER-DASH MICU FUSE/RELAY BOX (BEHIND LEFT SIDE OF DASH)
WHT WIRE
Go to component -> Tire pressure monitoring circuit -> POWER SUPPLY CIRCUIT/CONTROLLER
