Acura RDX II (2013-2015) controller controller area network Wiring diagram
This page shows the only wiring diagram for the component.controller controller area network, which is found in the car Acura RDX II (2013-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram controller controller area network (1 of 1)
ALTERNATOR
BATTERY
BATTERY SENSOR
BLK WIRE
BLU WIRE
BRN WIRE
CENTER JUNCTION BOX 2
CHARGING SYSTEM INDICATOR
COMPUTER DATA LINES SYSTEM
CONTROLLER CONTROLLER AREA NETWORK
DRIVE CIRCUIT INDICATOR
DRIVER'S JUNCTION BOX
ENGINE START/ STOP SWITCH
F-CAN H
F-CAN L
FUSE 1 1
FUSE 18
FUSE 2-3 ELD
FUSE 2-4
FUSE 29
FUSE 31
FUSE 5 FUSE 2
GAUGE CONTROL MODULE
GRN WIRE
HOT IN ON OR START
LT BLU WIRE
LT GRN WIRE
MICU
MULTI-INFORMATION DISPLAY
ORG/ WIRE
POWER CONTROL UNIT (RIGHT SIDE OF STEERING COLUMN)
POWER SUPPLY CIRCUIT
POWERTRAIN CONTROL MODULE (PCM) (RIGHT SIDE OF ENGINE COMPT)
RED WIRE
STARTING CIRCUIT
TRANSCEIVER F-CAN
UNDER-DASH FUSE/RELAY BOX (BEHIND LEFT SIDE OF DASH)
UNDER-HOOD FUSE/RELAY BOX (LEFT REAR OF ENGINE COMPT)
WHT WIRE
YEL WIRE
Go to component -> Charging circuit -> CONTROLLER CONTROLLER AREA NETWORK
