Acura MDX II facelift (2010-2013) (shorting bar are connected between pins connector b: 6-7, 8-9, 10-11, 24-25) wiring diagram
This page shows the only wiring diagram for the component.(shorting bar are connected between pins connector b: 6-7, 8-9, 10-11, 24-25), which is found in the car Acura MDX II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(shorting bar are connected between pins connector b: 6-7, 8-9, 10-11, 24-25) wiring diagram (1 of 1)
BLK WIRE
BLU WIRE
BRN WIRE
DRIVER'S SEAT BELT BUCKLE SWITCH (UNDER DRIVER'S SEAT)
ELECTRONIC SUSPENSION SYSTEM
FLBC LBSO FRBC RBSO SS+
FRONT PASSENGER'S SEAT BELT BUCKLE SWITCH (UNDER FRONT PASSENGER'S SEAT)
FUSE 1 (TECH)
FUSE 5
FUSE 6
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
LEFT SIDE IMPACT
LRP- LRP+ RRP- RRP+
LSA- LSA+ RSA- RSA+
LT BLU WIRE
LT GRN WIRE
MULTI-
ORG/ WIRE
PIN SHORTING BARS ENGAGED WHEN MODULE CONNECTOR IS DISCONNECTED
PNK (OR (OR WIRE
PNK WIRE
REAR SAFING SENSOR (MIDDLE OF FLOOR)
RED WIRE
RIGHT SIDE CURTAIN AIR BAG INFLATOR
RIGHT SIDE IMPACT
SRS UNIT (BEHIND LOWER CENTER OF DASH)
SSS- SSS+
TECH RELAY AUXILIARY UNDER-HOOD FUSE/RELAY BOX (RIGHT SIDE OF ENGINE COMPT)
WHT WIRE
YEL WIRE
Go to component -> Supplemental restraints circuit (3 of 3) -> (SHORTING BAR ARE CONNECTED BETWEEN PINS CONNECTOR B: 6-7, 8-9, 10-11, 24-25)
