Acura MDX II facelift (2010-2013) fluid pressure switch (transmission housing) wiring diagram
This page shows the only wiring diagram for the component.fluid pressure switch (transmission housing), which is found in the car Acura MDX II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
fluid pressure switch (transmission housing) wiring diagram (1 of 1)
A/T CLUTCH PRESSURE CONTROL VALVE A
A/T CLUTCH PRESSURE CONTROL VALVE B
A/T CLUTCH PRESSURE CONTROL VALVE C
A/T CLUTCH PRESSURE CONTROL VALVE D
ATP-P
BLK WIRE
BLK/WHT WIRE
BLU WIRE
BLU/BLK WIRE
BLU/WHT WIRE
BLU/YEL WIRE
BRN WIRE
BRN/WHT WIRE
COMPUTER DATA LINES SYSTEM
CONTROL CIRCUITS
FAST CONTROLLER AREA NETWORK TRANSCEIVER
FLUID PRESSURE SWITCH (TRANSMISSION HOUSING)
FUSE
FUSE 7 RELAY BOX (BEHIND LEFT KICK PANEL)
GAUGE CONTROL MODULE
GRN WIRE
GRN/RED WIRE
HOT AT ALL TIMES
HOT IN ON OR START
J/C
LINE PRESSURE SOLENOID VALVE A (TRANSMISSION HOUSING)
LINE PRESSURE SWITCH (TRANSMISSION HOUSING)
LT GRN WIRE
ORG/ WIRE
PPL
RED WIRE
RED/BLK WIRE
RED/WHT WIRE
SHIFT INDICATOR DRIVE
STARTING/ CHARGING SYSTEM
TRANSMISSION FLUID PRESSURE SWITCH
TRANSMISSION FLUID PRESSURE SWITCH A
TRANSMISSION FLUID PRESSURE SWITCH B
TRANSMISSION RANGE SWITCH (ON TRANSMISSION HOUSING)
UNDER-DASH FUSE/
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/GRN WIRE
YEL WIRE
YEL/GRN WIRE
Go to component -> A/t circuit (2 of 2) -> FLUID PRESSURE SWITCH (TRANSMISSION HOUSING)
